Error Message: Possible Cause:
| System Error #1 ( Drive Motor Error) |
The Motor connector is not properly connected. The Motor has failed. Controller failure. |
|
| System Error #2 (No Spinner Index Error) |
Spinner Motor may not be functioning. Controller failure. |
|
| System Error #3 (No active video) |
J1 shunt is not installed on AP27354. The AP140004 Board is defective. |
|
| System Error #4 (Cutter Error) |
The Cutter may have stopped. May have a faulty Cutter Parked Sensor. Set screw on the Cutter Motor pulley may have loosened. |
|
| System Error #5 (DC Lazy Loop error) |
Lazy Loop Motor failed. Controller failure |
|
| System Error #6 (Head Punch Error) |
Loose cable. Head Punch Motor failed. Controller failure. Parked Sensor faulty or misadjusted. |
|
| System Error #7 (Tail Punch error) |
Loose cable. Tail Punch Motor failed. Controller failure. Parked Sensor faulty or misadjusted. |
|
| System Error #8 (Pinch error) |
Loose cabling. Bad Pinch Motor. Incorrect Sensor adjustment. Defective sensor. |
|
| System Error #9 (Spinner speed test failure) |
Loose cable. Insufficient voltage / current Spinner Controller board fails to maintain speed. Bad Spinner |
Transport
Error
Message: Possible Cause:
| FLAP 1 CURRENT FLAP 2 CURRENT LIFT 1 CURRENT ROLLER CURRENT |
– The transport has detected a problem operating a flap, lift, or roller motor. – The flap or lift may be obstructed. – The flap, lift, or roller motor wire may be shorted. – Call Service if problem persists. |
|
| FLAP 1 TIMEOUT FLAP 2 TIMEOUT LIFT 1 TIMEOUT |
– The transport flap or lift has not arrived at its destination on time. – The flap or lift may be obstructed. – The flap or lift wire may be loose. – Call Service if problem persists. |
|
| SENSOR TIMEOUT | – The media did not reach the sensor on time. – Sensor 3 does not detect leading edge of media within 30 seconds when MOVING MEDIA. – Sensor 4 does not detect the trailing edge of media when BUFFER 2 LOADING. – Sensor 4 does not detect the trailing edge of media when LOADING CASSETTE. – The sensor leads may be loose. – The sensor may be out of alignment. – The sensor may be bad. |
|
| KEYPAD ABORT | – You have initiated abort by pressing the STOP key while the roller was moving media. | |
| EEPROM CRC | – The Transport has failed to remember setup values stored in EEPROM. – The Transport may have lost power while you were storing values. – Press PREV left arrow on the Transport Controller Board to clear this error. Default values will be stored to EEPROM. |
|
| VOLTAGE HIGH VOLTAGE LOW |
– Power-On Self-Test error. – Power input(s) to transport PCB is/are missing or out of tolerance. – The connector may be loose or missing. |
|
| SENSOR STATE | – Power-On Self-Test error. – The transport program cannot resolve the current state of transport. – The sensor leads may be loose. – The sensor may be out of alignment. – The sensor may be bad. |