| Serial Error | An internal communication error occurred. Re-boot the machine. | |
| JAM1 | The plate is jammed. Cutter not completed cut. | |
| JAM2 | The plate is jammed. Continual discharge. | |
| JAM3 | The plate is jammed. Plate not discharged. | |
| I/F Error 1 | A SCSI communication error occurred. Re-boot the machine. | |
| ME1 | The Cutter does not return to its initial position. Turn on the Power Switch again. |
|
| ME2 | The Cutter in not located at its initial position. Turn on the Power Switch again. |
|
| ME3 Nip Free | The Nip Roller is open. Close the Nip Roller clearance handle. | |
| ME4 | An internal communication error occurred in the machine | |
| ME5 | An internal communication error occurred. Re-boot the machine. | |
| ME6 | The Laser does not light. It may be caused by low Laser. | |
| ME7 | A problem occurred in the Polygon Mirror. | |
| ME8 | A problem occurred in the Processor Heater. | |
| ME9 | A problem occurred in the Heat Roller. | |
| ME10 | A problem occurred when the Punch Unit was activated. | |
| Disk 01 Error | It may be impossible to use the Disk “01”. | |
| Disk 02 Error | It may be impossible to use the Disk “02”. | |
| Disk Not Found | The Hard Disk drive cannot be found. | |
| Disk Crash | The Hard Disk drive mounted on this machine cannot be used. | |
| Please Format HD | The Hard Disk is not formatted. | |
| HD Partition Error | Format the Hard Disk. | |
| Punch Un-mounted | The Punch is not mounted. | |
| Close Front Door | The front door is open. Shut the door. | |
| Width Not Enough | The width of the plate is insufficient for the exposure width. Replace the plate with one as wide as the exposure. |
|
| Image Error | An internal data transmission error occurred. Re-boot machine. | |
| Plate Set Error | The plate has not been set correctly. Re-set the plate. | |
| Plate End | The plate ran out. Load new plate. | |
| Pick Up Plate | Open the front door end remove a strip type plate through the plate removal port. |
|
| Waste Tank Check | The waste chemical tank is full. | |
| Empty EAC | The EAC chemical ran out. Replenish it. | |
| Empty EST | The EST chemical ran out. Replenish it. | |
| Tray Check | The overflow try has not been set. Set the tray. |